Homework:
Chapter 4:
Lab: 4.1.4.5 - you can convert it to a packet tracer lab
Read: 4.2
Do: Activity 4.2.2.5
Read 4.3
Do Activity 4.3.1.4
Packet Tracer : 5.4.1.2
Thursday: We will start Chapter 5 Inter-VLAN Routing
Tuesday, April 15, 2014
Sunday, April 13, 2014
14 April 2014 - Networking for IT Essentials
Let's finish making cables.
Follow lab 6.4.2.4 use a piece of masking tape to label the cable w your name.
Packet tracer 6.4.2.5
Review logical and physical topologies - 6.5.1
Packet tracer 6.5.1.2
Ethernet standards 6.6
IEEE 802.3 = CSMA/CD what is that?
Create a table of wireless standards
Read and take notes on 6.7 & do the end of section activity.
Follow lab 6.4.2.4 use a piece of masking tape to label the cable w your name.
Packet tracer 6.4.2.5
Review logical and physical topologies - 6.5.1
Packet tracer 6.5.1.2
Ethernet standards 6.6
IEEE 802.3 = CSMA/CD what is that?
Create a table of wireless standards
Read and take notes on 6.7 & do the end of section activity.
OSI Model video link. Use videonot.es to take notes.
A good reference
Today we will complete our rendering of the OSI model on the wall.
Create your own mnuemonic for OSI
6.8.1.1 - Make a poster listing network installation steps - use words, pictures.....
Everyone can make their own on a sheet of 8 x 11
Keep reading about NIC installation - we only have 2 wireless NICs. Do the Packet tracer lab.
Monday, April 7, 2014
7 April 2014 - Initial Switch Configuration
Initial Switch Configuration
Initial Router Configuration
http://computernetworkingnotes.com/switching-vlan-stp-vtp-dtp-ether-channels/configure-vlan-vtp.html
- Set hostname
- Set privileged EXEC mode password (enable password xxxxx)
- Set privileged EXEC mode secret password (enable secret xxxxx)
- Configure the console and VTY lines to use a password
- Configure the Switch Management Interface on VLAN1
- interface vlan1
- set the IP address, subnet mask and default gateway
- Save Configuration
Initial Router Configuration
- Set hostname
- Disable DNS - (no ip domain-lookup)
- Set privileged EXEC mode password (enable password xxxxx)
- Set privileged EXEC mode secret password (enable secret xxxxx)
- Configure MOTD
- Configure the console and VTY lines to use a password
- Configure interfaces and static routing
- fastethernet or gigabit
- serial - don't forget clock rate for DCE side
- Create static route (ip route )
- Save Configuration
Configure a Routing Protocol
- remove static route
- enable routing protocol
http://computernetworkingnotes.com/switching-vlan-stp-vtp-dtp-ether-channels/configure-vlan-vtp.html
Subscribe to:
Posts (Atom)